Bonjour,
J'ai pris un petit OCZ Onyx 64Go pour mon portable, tout marche bien, en mode AHCI, même si je n'ai pas accès au SMART.
Sur le site d'OCZ ( http://www.ocztechnologyforum.com/ [...] n_a_VERTEX ), on peut lire ceci
Citation :
For all other windows based OS with no TRIM support...The simple answer is an application called Wiper.exe. The latest version available to use is 0525 and is linked here for download.
From a fresh brand new drive wiper.exe if run each day will take around 2 minutes max to run and will reset the deleted blocks on the drive to ensure you see full speed. VERTEX works best in IDE mode but AHCI is supported. There are issues with AHCI that need slightly different rules to be applied which i will outline below.
1 Wiper.exe used on a drive in IDE mode will work very fast and is only needed 2 to 3 times per week.
2 Wiper.exe used on a drive in AHCI mode does best when Wiper is run at the start of each new session. If the drive is moving and deleting large amounts of data within a session it may be best to run wiper a few times within that session also. In general at the start of each session should be all that is needed.
|
Mes connaissances en anglais étant faibles, que dois-je conclure ? Que je formate et que j'installe en mode IDE ( et pas en AHCI ) ?
Merci
---------------
Config principale: InWin GRone blanc - Seasonic Prime Ultra 550W Platinum - ASRock B450 Pro4 - Ryzen 5800X - 2x16Go 3200Mhz Ripjaws 5 - RTX 4070 XLR8 - SSD 2 X 970Evo Plus 2To