Ca en fait des lignes...
--------------------------------------
[ 0.000000] microcode: microcode updated early to revision 0x28, date = 2019-11-12
[ 0.000000] Linux version 4.18.0-305.19.1.el8_4.x86_64 (mockbuild@kbuilder.bsys.centos.org) (gcc version 8.4.1 20200928 (Red Hat 8.4.1-1) (GCC)) #1 SMP Wed Sep 15 15:39:39 UTC 2021
[ 0.000000] Command line: BOOT_IMAGE=(hd0,gpt2)/vmlinuz-4.18.0-305.19.1.el8_4.x86_64 root=/dev/mapper/cl-root ro crashkernel=auto resume=/dev/mapper/cl-swap rd.lvm.lv=cl/root rd.lvm.lv=cl/swap rhgb quiet
[ 0.000000] x86/fpu: Supporting XSAVE feature 0x001: 'x87 floating point registers'
[ 0.000000] x86/fpu: Supporting XSAVE feature 0x002: 'SSE registers'
[ 0.000000] x86/fpu: Supporting XSAVE feature 0x004: 'AVX registers'
[ 0.000000] x86/fpu: xstate_offset[2]: 576, xstate_sizes[2]: 256
[ 0.000000] x86/fpu: Enabled xstate features 0x7, context size is 832 bytes, using 'standard' format.
[ 0.000000] BIOS-provided physical RAM map:
...
[ 29.919852] Bluetooth: BNEP filters: protocol multicast
[ 29.919855] Bluetooth: BNEP socket layer initialized
[ 36.654371] IPv6: ADDRCONF(NETDEV_UP): eno1: link is not ready
[ 36.832352] IPv6: ADDRCONF(NETDEV_UP): eno1: link is not ready
[ 36.835224] IPv6: ADDRCONF(NETDEV_UP): wlp2s0: link is not ready
[ 37.155320] IPv6: ADDRCONF(NETDEV_UP): wlp2s0: link is not ready
[ 37.347898] IPv6: ADDRCONF(NETDEV_UP): wlp2s0: link is not ready
[ 37.415922] Lockdown: x86_energy_perf: Direct MSR access is restricted; see man kernel_lockdown.7
[ 37.415923] msr: Direct access to MSR 1b0
[ 37.418989] msr: Direct access to MSR 1b0
[ 37.422276] msr: Direct access to MSR 1b0
[ 37.425461] msr: Direct access to MSR 1b0
[ 37.516218] IPv6: ADDRCONF(NETDEV_UP): wlp2s0: link is not ready
[ 46.816905] bridge: filtering via arp/ip/ip6tables is no longer available by default. Update your scripts to load br_netfilter if you need this.
[ 46.850281] tun: Universal TUN/TAP device driver, 1.6
[ 46.851418] virbr0: port 1(virbr0-nic) entered blocking state
[ 46.851419] virbr0: port 1(virbr0-nic) entered disabled state
[ 46.851535] device virbr0-nic entered promiscuous mode
[ 48.989722] virbr0: port 1(virbr0-nic) entered blocking state
[ 48.989724] virbr0: port 1(virbr0-nic) entered listening state
[ 49.035828] virbr0: port 1(virbr0-nic) entered disabled state
[ 57.425497] e1000e 0000:00:19.0 eno1: NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[ 57.425498] e1000e 0000:00:19.0 eno1: 10/100 speed: disabling TSO
[ 57.425528] IPv6: ADDRCONF(NETDEV_CHANGE): eno1: link becomes ready
[ 68.640946] Bluetooth: RFCOMM TTY layer initialized
[ 68.640951] Bluetooth: RFCOMM socket layer initialized
[ 68.640988] Bluetooth: RFCOMM ver 1.11
[ 74.706093] rfkill: input handler disabled
[ 187.095650] usb 3-2: new high-speed USB device number 5 using xhci_hcd
[ 187.222456] usb 3-2: New USB device found, idVendor=0d49, idProduct=7350, bcdDevice= 1.25
[ 187.222458] usb 3-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 187.222459] usb 3-2: Product: OneTouch
[ 187.222459] usb 3-2: Manufacturer: Maxtor
[ 187.222460] usb 3-2: SerialNumber: 2HAPKBER
[ 187.303333] usb-storage 3-2:1.0: USB Mass Storage device detected
[ 187.303612] scsi host6: usb-storage 3-2:1.0
[ 187.303678] usbcore: registered new interface driver usb-storage
[ 187.310984] usbcore: registered new interface driver uas
[ 188.335248] scsi 6:0:0:0: Direct-Access Maxtor OneTouch 0125 PQ: 0 ANSI: 4
[ 188.335448] sd 6:0:0:0: Attached scsi generic sg1 type 0
[ 188.335642] sd 6:0:0:0: [sdb] 488397168 512-byte logical blocks: (250 GB/233 GiB)
[ 188.336479] sd 6:0:0:0: [sdb] Write Protect is off
[ 188.336480] sd 6:0:0:0: [sdb] Mode Sense: 2d 08 00 00
[ 188.336770] sd 6:0:0:0: [sdb] No Caching mode page found
[ 188.336772] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 188.361101] sdb: sdb1
[ 188.362291] sd 6:0:0:0: [sdb] Attached SCSI disk
----------------------------------------------------------------
Et si je passe par le mode graphique "fichier", le DD apparait bien ; en cliquant dessus j'ai le message :
Impossible d'accéder à OneTouch
Error mounting /dev/sdb1 at /run/media/user/OneTouch : unknown filesystem type 'ntfs'
Message édité par pollux59510 le 15-10-2021 à 14:01:27
---------------
Si un problème a une solution, il ne sert à rien de s'inquiéter.