Salut,
Ma carte mère (une KT4V de MSI) est limitée à 1.75v au voltage. Je voudrais donc faire un mod vcore et j'ai donc cherché une doc afin de réaliser ça. Voilà ce que j'ai trouvé:
Citation :
Hi,
I saw the tread about the vmod archive so i tought: lets help a bit!
So: Locate the upper chip, solder a 30-35K pot to pin 7 and connect to the ground, set the pot @ max resitance and turn VERY SLOWLY down while checking the voltage in the bios...
schéma:
http://www.xtremeresources.com/for [...] entid=8986
|
source: http://www.xtremeresources.com/for [...] hp?t=29443
Mais comment faire pour savoir quel voltage supplémentaire on envoie au proco avec cette manip? Y a--t-il des précautions particulières à prendre pour réaliser cette manip? Et est-ce que c'est risqué pour ma cm?
Merci d'avance!
Message édité par real_mathos le 21-05-2004 à 18:40:46