die488 | Bonsoir,
Je possède une clé USB 2 qui se monte automatiquement sur la Suse 9.1 du boulot mais qui sur man mandrake 10 (powerpack) de la maison de se monte pas et ne semble pas utilisable...
Hotplug semble lancé et voici le contenu de /var/log/syslog lorsque j'insère la clé :
Code :
- Jun 19 23:42:10 cable-62-205 kernel: scsi2 : SCSI emulation for USB Mass Storage devices
- Jun 19 23:42:10 cable-62-205 kernel: Vendor: Generic Model: USB Flash Disk Rev: 2.00
- Jun 19 23:42:10 cable-62-205 kernel: Type: Direct-Access ANSI SCSI revision: 02
- Jun 19 23:42:10 cable-62-205 kernel: sda: Unit Not Ready, sense:
- Jun 19 23:42:10 cable-62-205 kernel: Current : sense key Unit Attention
- Jun 19 23:42:10 cable-62-205 kernel: Additional sense: Not ready to ready change, medium may have changed
- Jun 19 23:42:10 cable-62-205 kernel: SCSI device sda: 255488 512-byte hdwr sectors (131 MB)
- Jun 19 23:42:10 cable-62-205 kernel: sda: assuming Write Enabled
- Jun 19 23:42:10 cable-62-205 kernel: sda: assuming drive cache: write through
- Jun 19 23:42:10 cable-62-205 kernel: /dev/scsi/host2/bus0/target0/lun0: inconsistent partition table (overlap)
- Jun 19 23:42:10 cable-62-205 kernel: Attached scsi removable disk sda at scsi2, channel 0, id 0, lun 0
- Jun 19 23:42:10 cable-62-205 kernel: Attached scsi generic sg0 at scsi2, channel 0, id 0, lun 0, type 0
- Jun 19 23:42:10 cable-62-205 kernel: WARNING: USB Mass Storage data integrity not assured
- Jun 19 23:42:10 cable-62-205 kernel: USB Mass Storage device found at 4
- Jun 19 23:42:11 cable-62-205 scsi.agent[7205]: disk at /devices/pci0000:00/0000:00:02.2/usb3/3-6/3-6:1.0/host2/2:0:0:0
|
Si vous aviez une idée...
Merci d'avance |
