| impulse |
Voila ce que dit l'auteur de MicroDVD pour ton pb : a écrit :
Q: When I switch to fullscreen, I get a big black box or a frozen Frame all over the movie, just leaving a small stripe of correct video at the left and right screen edge. Why?
A: When switching to fullscreen, the transparent overlay window is initialized to later display OSD and subtitles. This initialization uses some kind of trick, is quite timing critical and dependant on some external circumstances.
You must make sure some requirements are met for it to work:
You must make sure the running video has enough time to "settle down" (means the next keyframe of the AVI must occur before the init is done).
Use the setting Minimum Wind/Sync Delay in configuration to do this. The timer runs for 3 times the Min.W/S Delay. Do not click the mouse or press keys while the init timer is running.
If that does not help, try decreasing the refresh rate of you graphics card. Make sure there's not too much background/harddrive activity that might disturb the init process. If in doubt, increase the Min.W/S Delay.
The bug can also be caused when the width and/or height of the video you are playing is not a multiple of 16 (e.g. 688,704,720 etc.), and for some systems a multiple of 32 (e.g. 672,704,736 etc.). If in doubt, pay attention to this too!
Furthermore, you must make sure the DirectShow Filters for the MPEG4 codec you use are properly registered. If in doubt, go to your WINDOWS\SYSTEM directory and type: RegSvr32 DIVX_C32.AX if you are using DIVX, or RegSvr32 MPG4DS32.AX if using the MS MPEG4
After initialization is complete and successful, it may happen later that you get a black screen too, especially after intense switching between modes and starting/stopping movies. In that case, a click on the movie window should do.
Important: On some systems and codecs, the transparency totally fails due to behaviour of the graphics card, codec etc. I unfortunately was not yet able to find out the exact cause. If you have permanent trouble with the black box, you can turn off transparent subtitles (and thus unfortunately disabling OSD) in the configuration dialog, section SUBTITLES
|
hihi :p
--Message édité par impulse--
|
