Slt , j'ai un souci pour configurer ma carte WIFI sous mandrake 10.1
Alors le module est bien chargé , avec iwconfig je vois bien la carte , mais voila , lorsque j'essaie de passer en arguments la clef , j'ai une erreur :
Citation :
[root@guynemer4 portable]# iwconfig eth2
eth2 IEEE 802.11b ESSID:"le ssid de mon point d acces" Nickname:"mon nom de machine"
Mode:Managed Channel:1 Access Point: 00:00:00:00:00:00
Bit Rate=0kb/s Tx-Power=32 dBm
Retry:on RTS thr=2304 B Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:158
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root@guynemer4 portable]# iwconfig eth2 key open
Error for wireless request "Set Encode" (8B2A) :
SET failed on device eth2 ; Operation not supported.
|
Si qqu'un pouvait m'aider pour m'en sortir svp ...
Le plus étrange , c'est que ca marchait juste apres l'installation de Mandrake , et puis hop d'un coup , ca n'a plus marché ...