Bonjour,  
 
J'ai effectuer une modélisation dúne plaque sous abaqus et après avoir simulé 2 "Jobs", j'en ai créé un 3ème qui ne fonctionne pas.
Le message qui apparait en bas de la fenêtre est le suivant:
 
"Error in job PlSkewPlate: Too many attempts made for this increment
Job PlSkewPlate: Abaqus/Standard aborted due to errors.
Error in job PlSkewPlate: Abaqus/Standard Analysis exited with an error - Please see the  message file for possible error messages if the file exists.
Job PlSkewPlate aborted due to errors. "
 
Et lorque j'ouvre le fichier message, il y est indiqué ceci:
 
"INCREMENT     1 STARTS. ATTEMPT NUMBER  5, TIME INCREMENT  3.906E-04
 
 ***WARNING: THERE ARE NO CONTACT CONSTRAINTS TREATED BY CONTACT ITERATIONS.  
             CONTACT ITERATIONS ARE ABANDONED.
 
 ***WARNING: THE STRAIN INCREMENT HAS EXCEEDED FIFTY TIMES THE STRAIN TO CAUSE  
             FIRST YIELD AT 960 POINTS
 
 ***WARNING: THE STRAIN INCREMENT IS SO LARGE THAT THE PROGRAM WILL NOT ATTEMPT  
             THE PLASTICITY CALCULATION AT 960 POINTS
 
 
 ***NOTE: MATERIAL CALCULATIONS FAILED TO CONVERGE OR WERE NOT ATTEMPTED AT ONE  
          OR MORE POINTS. CONVERGENCE IS JUDGED UNLIKELY.
 
 
 ***ERROR: TOO MANY ATTEMPTS MADE FOR THIS INCREMENT  "
 
 
Quelqu'un aurait-t-il une idée de l'origine du probème?
 
Merci