sa dépend des disque durs en gros, mais il y a un logiciel pour vérifier sa
Speed fan fait à 300% l'affaire ! il peut afficher sa :
Your hard disk is a WDC WD5000AAKS-00TMA0 with firmware 12.01C01.
The average temperature for this hard disk is 36C (MIN=27C MAX=47C) and yours is 45C.
Your hard disk's S.M.A.R.T. attributes are now being analyzed and a full report about the reliability, health and status of your hard disk is generated:
Your hard disk is not below any attribute threshold. This is good.
Your hard disk was never below any attribute threshold. This is good.
Your hard disk is now being compared to real data used to define normal values for your specific hard disk model. This way, the analysis can automatically use proper operating ranges. The images give you an idea of how each attribute is within such range. Current and raw values are shown for easier reference for experienced users. There are 1603 hard disk models in the current archive.
Attribute Current Raw Overall
Raw Read Error Rate 200 0 Very good
Spin Up Time 176 6183 Very good
Start/Stop Count 100 243 Very good
Reallocated Sector Count 200 0 Very good
Seek Error Rate 200 0 Very good
Power On Hours Count 100 711 Very good
Spin Retry Count 100 0 Very good
Calibration Retry Count 100 0 Very good
Power Cycle Count 100 146 Very good
Power Off Retract Count 200 102 Very good
Load Cycle Count 200 244 Very good
Reallocated Event Count 200 0 Very good
Current Pending Sector 200 0 Very good
Offline Uncorrectable Sector Count 200 0 Very good
Ultra DMA CRC Error Rate 200 0 Very good
Write Error Rate 200 0 Very good
All of the attributes of your hard disk have normal values. This is good.
The overall fitness for this drive is 98%.
The overall performance for this drive is 100%.
Message édité par paulothekid le 25-06-2007 à 12:16:07