 |
||
| ||
| |||||
| Dernière réponse | |
|---|---|
| Sujet : Aidez-moi: pb proxy et pop, ftp | |
| fox25 | Voici ce qu'il y a de noter comme aide:
Si quelqu'un peut m'aider avec ce texte. :::Configuring Email::: Configuring Email is a little trickier, so make sure you have the web browser proxy working properly before doing this. You now have two methods, one is to use the method described below, which can sometimes be a pain to get working, the other is to just use Socks4 and a client that either supports it, or works with Socksify (refer to the section below about Socks). If you want to try the normal method, open up the 'Configure' menu, and select 'Configure Email Alias's'; you'll be presented with the email account configuration area. Select 'Add' from the menu; this is where you will enter in the servers you check your email from... First, you need to enter the email address that people send messages to, like 'bob@domain.com'. Next, you need to set the POP3 server, which is where your email program goes when it receives email; normally this will be something along the lines of 'pop3.domain.com' or 'mail.domain.com'. Finally, you need to set the SMTP server, which is what your emails are sent through, which in the above example could be something like 'smtp.domain.com'. Now, it's important to note that not every service uses two different names for the server, you might check both POP3 and SMTP from the same server; in this case you can just leave the SMTP field blank. That's it for the proxy! Now you have added email support for this particular user. Now you need to set up the configuration of the email program you use; this varies from program to program, but you need to go to wherever you enter both the servers that the program checks. Now, instead of entering 'mail.domain.com' or whatever your mailserver is, you'll enter the IP address of your proxy server, such as '10.0.0.1'. It's important to note that you won't need to change the port settings in the email program, since the proxy uses the same ports a normal server would. Also, you will set both the SMTP, as well as the POP3 servers to the same IP address; the proxy will make sure they get to the correct place. Now, let's check out your configuration; try sending an email to yourself... If everything is configured properly, they you should be good to go! One more thing to note about email; it will only support using a certain username once; for example, you can't have bill@homecomputer.com and bill@workcomputer.com; but you can have bill@homecomputer.com and sue@another.com. In most cases this shouldn't be a problem for users, since most people have different usernames for each account... The reason I decided to do it this way was to make it easier to configure email programs, but there's always a minus to each plus. One other note about email; if you have a different login name than email name (like you check mail by using the login name bill, but your email address is billyg@computer.com), then you'll need to create TWO alias in the email section; one just like normal, using billyg@computer.com, and one using the login name in place of the email name (so bill@computer.com). |
| Vue Rapide de la discussion |
|---|
