| BMenez |
Citation :
2.3.5 Domain
A domain (or domain name) consists of one or more dot-separated
components. These components ("labels" in DNS terminology [22]) are
restricted for SMTP purposes to consist of a sequence of letters,
digits, and hyphens drawn from the ASCII character set [1]. Domain
names are used as names of hosts and of other entities in the domain
name hierarchy. For example, a domain may refer to an alias (label
of a CNAME RR) or the label of Mail eXchanger records to be used to
deliver mail instead of representing a host name. See [22] and
section 5 of this specification.
The domain name, as described in this document and in [22], is the
entire, fully-qualified name (often referred to as an "FQDN" ). A
domain name that is not in FQDN form is no more than a local alias.
Local aliases MUST NOT appear in any SMTP transaction.
|
Citation :
3.6 Domains
Only resolvable, fully-qualified, domain names (FQDNs) are permitted
when domain names are used in SMTP. In other words, names that can
be resolved to MX RRs or A RRs (as discussed in section 5) are
permitted, as are CNAME RRs whose targets can be resolved, in turn,
to MX or A RRs. Local nicknames or unqualified names MUST NOT be
used. There are two exceptions to the rule requiring FQDNs:
- The domain name given in the EHLO command MUST BE either a primary
host name (a domain name that resolves to an A RR) or, if the host
has no name, an address literal as described in section 4.1.1.1.
- The reserved mailbox name "postmaster" may be used in a RCPT
command without domain qualification (see section 4.1.1.3) and
MUST be accepted if so used.
|
Citation :
4.1.3 Address Literals
Sometimes a host is not known to the domain name system and
communication (and, in particular, communication to report and repair
the error) is blocked. To bypass this barrier a special literal form
of the address is allowed as an alternative to a domain name. For
IPv4 addresses, this form uses four small decimal integers separated
by dots and enclosed by brackets such as [123.255.37.2], which
indicates an (IPv4) Internet Address in sequence-of-octets form. For
IPv6 and other forms of addressing that might eventually be
standardized, the form consists of a standardized "tag" that
identifies the address syntax, a colon, and the address itself, in a
format specified as part of the IPv6 standards [17].
|
|
