|
Sujet : probleme inpout/output error avec mt-st |
| lebibi |
st: Unloaded.
scsi : 0 hosts left.
PCI: Enabling device 00:0d.0 (0016 -> 0017)
PCI: Found IRQ 3 for device 00:0d.0
PCI: Sharing IRQ 3 with 00:04.2
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
<Adaptec 2930CU SCSI adapter>
aic7860: Ultra Single Channel A, SCSI Id=7, 3/253 SCBs
(scsi0:A:0): 10.000MB/s transfers (10.000MHz, offset 15)
Vendor: SONY Model: SDT-7000 Rev: 0300
Type: Sequential-Access ANSI SCSI revision: 02
st: Version 20040102, bufsize 32768, max init. bufs 4, s/g segs 16
Attached scsi tape st0 at scsi0, channel 0, id 0, lun 0
st0: Block limits 1 - 16777215 bytes.
st0: Error with sense data: Current st09:00: sense key Medium Error
Additional sense indicates Write append error
st0: Error with sense data: Current st09:00: sense key Hardware Error
Additional sense indicates Internal target failure
|
Faut que je test avec un autre :/ |
