| ilien83 |
noooky a écrit a écrit :
:D ben c pour savoir comment mettre ma 2eme barette de 256 paske si je la mets ca beeeeepp et ca boot po !!!!!
compris ? :lol:
++
|
:lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol:
Peu-être parce qu'elle n'accepte que 384 Mo :
The P6BAT-A+ is a full-sized ATX board measuring 305x220mm and using 4-layer printed circuit board. The P6BAT-A+ V2.0/2.2 has a special design feature so that it includes a Slot-1 processor slot and a PPGA (Plastic Pin Grid Array) Celeron Socket-PGA370 processor socket. This feature means that you can install the mainboard with either a Pentium-III cartridge, a Pentium-II cartridge, the SEPP (Single Edge Processor Package) Celeron cartridge, or one of the new generation PPGA Celeron processors. In addition, the mainboard supports a 66 MHz memory bus, or a 100 MHz memory bus, so you can use inexpensive 66MHz memory chips, or higher-performance PC-100 memory chips. The board is installed with an integrated PCI-3D sound system and has a full suite of I/O ports. Seven expansion slots are available for system development and hardware monitoring is supported. This board allows complete flexibility. System integrators can choose the high-performance Slot -1 processor or the inexpensive PPGA Celeron processor according to the system requirements and the price/performance comparison of the two kinds of processor.
PROCESSORS Detail
SECC2 Pentium III up to 850MHz(100MHz FSB), Pentium II
FC-PGA Pentium III up to 850MHz(100MHz FSB)
Celeron PPGA up to 533MHz
Cyrix III up to 550MHz(100MHz FSB)
CHIPSET
VIA 82C693A & 82C596B
CMI8738 PCI 3D Audio Chip on board
MEMORY
Three 168-pin DIMMs
Maximum: 384MB
:cry: :cry: :cry: :cry: :cry: :cry: |
