Bonjour,
J’ai quelques questions sur le spanning tree cisco.
J’ai un réseau composé de 3 switch hétérogène en modèles. Les deux qui me posent problèmes sont un cisco SG200 (small business) et un cisco catalyst 3750.
J’aimerais maitriser mon spanning tree de bout en bout. Or mon problème est que mon 3750 fait du spanning tree par Vlan et non une instance globale sur le VLAN1.
Comment désactiver le mode PVST sur mon 3750 ?
Code :
- SW1#show version
- Cisco IOS Software, C3750 Software (C3750-IPSERVICESK9-M), Version 12.2(55)SE6, RELEASE SOFTWARE (fc1)
- SW#show spanning-tree
- VLAN0001
- Spanning tree enabled protocol ieee
- Root ID Priority 0
- Address 10bd.18be.0000
- Cost 20019
- Port 26 (FastEthernet1/0/24)
- Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
- Bridge ID Priority 32769 (priority 32768 sys-id-ext 1)
- Address 0015.f9be.0000
- Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
- Aging Time 300 sec
- Interface Role Sts Cost Prio.Nbr Type
- ------------------- ---- --- --------- -------- --------------------------------
- Fa1/0/24 Root FWD 19 128.26 P2p
- VLAN002
- Spanning tree enabled protocol ieee
- Root ID Priority 32770
- Address 0015.f9be.0000
- This bridge is the root
- Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
- Bridge ID Priority 32770 (priority 32768 sys-id-ext 2)
- Address 0015.f9be.0000
- Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
- Aging Time 300 sec
|
J’ai testé la commande suivante et mon réseau n’est jamais remonté.
Code :
- SW02-3750-24P(config)#no spanning-tree mode pvst
- mst Multiple spanning tree mode
- pvst Per-Vlan spanning tree mode
- rapid-pvst Per-Vlan rapid spanning tree mode
|
Message édité par isaac76 le 04-06-2013 à 10:15:29